8 Pack and 4 Pack Assembly

image1.png

1. Lay one instert flat, printed side up.

image2.png

2. Fold each panel from one side 90 degrees until the pad makes a complete square.

image3.jpg

3. Do the same to the other side. Fold top flaps to meet in the middle then fold over.

image5.png

4. Lay next pad flat, back side up

image6.png

5. Repeat steps 2 and 3

image6.jpg

6. Place cans into each slot and slide inserts into each other so that each can is covered at the top and bottom.

image7.jpg

7. For 8 packs, repeat previous steps and stack two layers into box. For 4 packs, insert one layer into box.